Changes

Jump to: navigation, search

ADS-B

229 bytes removed, 10:53, 11 April 2019
m
no edit summary
=== Receiver ===
<br>
UgCS gives warnings about dangerous convergences concerning vehicles controlled by UgCS, and vehicles observed by UgCS, via the microADS-B receiver. <br>
[[File:Image54.png|1000px|thumb|center|ADS-B icon]]
<br>
To display the ADS-B monitor window, click on the ADS-B icon (Figure 37) at the very top right-hand corner of the screen.
<br>
[[File:Image55.png|1000px|thumb|center|Figure . ADS-B monitor window]]
* The minimal convergence persisted in the past and the spread angle between the trajectories is more than 20 degrees;
<br>
* The minimal convergence persisted in the past and spread angle between the trajectories is less, than 20 degrees and the areas of the vehicles are not violated.
<br>
Warnings are created only for vehicles which have been that were added to the vehicle list. When control is released, all current alerts for that vehicle are removed.
<br>
An indicator in the top right corner shows whether any ADS-B receivers are currently connected. It is displayed green if a connection with at least one such device is active, and grey otherwise.
=== Transponder ===
<br>
If your the vehicle is equipped with an ADS-B Transponder or you wish to do sowill be at some point, it is possible to configure and transmit ADS-B messages using UgCS. As of this moment , UgCS supports Sagetech XPS-TR Mode S transponders. The following main functions for ADS-B Transponder configuration and usage are available:
<br>
* To set ADS-B modes;
Transponder parameter usage:
<br>
* ICAO Address and Aircraft registration/Tail number will remain the same for a specific vehicle in most of the cases. These parameters can be set in Vehicle Parameters section [https://wiki.ugcs.com/File:Image57.png Vehicle parameter menu where Tail number and ICAO address can be set] ).
<br>
* SQUAWK parameter can be defined when necessary any time during the flight [https://wiki.ugcs.com/File:Image56.png ADS-B settings menu for reference].
<br>
* Flight ID should be set during preparation for take-off. That can be is done in the Preflight section ADS-B settings menu for reference.
<br>
[[File:Image57.png|1000px|thumb|center| Vehicle parameter menu where Tail number and ICAO address can be set]]

Navigation menu