Difference between revisions of "How to use DJI simulator with UgCS for iOS"
(Created page with "Category:How to use DJI simulator with UgCS for iOS <u> '''''[https://wiki.ugcs.com/Main_Page Main Page]'''''</u> <u> '''''[https://wiki.ugcs.com/UgCS UgCS]'''''</u> <u>...")
Latest revision as of 10:29, 11 February 2020
- Turn on the laptop with an installed UgCS desktop
- Turn on the iOS mobile device with installed UgCS for DJI on it
- Create a WiFi access point on the iOS mobile device
- Connect your laptop to the created WiFi access point
- Run UgCS
- Remove propellers of the drone
- Turn on the drone
- Turn on the drone’s Remote Controller (RC)
- Connect the RC with the iOS device
- If the UgCS for DJI doesn’t start automatically, launch it
- When the connection with the drone has been established, check that the UCS indicator of UgCS for DJI is green and that UgCS desktop is displaying telemetry of the drone
- In UgCS for DJI choose Settings - DJI - Simulator and switch it to green position, than close the settings menu.
- Now GPS data will be transferred (by default the drone will be placed at the Spilve airport in Riga, Latvia)
- Check that the drone is in DISARM status and upload the route to the drone. Upon successful upload, the drone will be placed on the first waypoint / Home location of your mission
- Click “Auto Mode” and accept the command in either UgCS or UgCS for DJI – the drone should start the mission.
In the simulation mode, it is possible to follow the flight of the drone in UgCS and control whether pictures are taken according to the route’s settings (if turn type “Stop & Turn” is in use).