Difference between revisions of "How to use facade scanning tool"

From UgCS
Jump to: navigation, search
(One intermediate revision by the same user not shown)
Line 3: Line 3:
  
  
#Unfold and connect the software and hardware drone components
+
1. Unfold and connect the software and hardware drone components<br>
#Launch UgCS for desktop
+
2. Launch UgCS for desktop<br>
#Click "Add new route"
+
3. Click "Add new route"<br>
#Select "Create from scratch"
+
[[File:Add new roue.jpg|center|350px]]<br>
#Give a friendly name to the route
+
4. Select "Create from scratch"<br>
#Select the used vehicle and click OK
+
[[File:Scratch.jpg|center|center|350px]]<br>
#Input take off parameters if different from default and click OK
+
5. Give a friendly name to the route<br>
#Select Facade scanning tool
+
6. Select the used vehicle and click OK<br>
#Select the facade on the map to scan
+
[[File:Name.jpg|center|350px]]<br>
#Input the maximum and minimum height above the ground relief the vehicle should fly
+
7. Input take off parameters if different from default and click OK<br>
#Upload the route to the vehicle
+
[[File:Takeoff.jpg|center|350px]]<br>
#Switch the vehicle to Auto mode<br>
+
8. Select Facade scanning tool<br>
 +
[[File:Facade.jpg|center|150px]]<br>
 +
9. Select the facade on the map to scan<br>
 +
[[File:Facade scan.jpg|center|550px]]<br>
 +
10. Input the flight parameters such as turn type - "Stop and turn". Maximum and minimum height above the ground relief the vehicle should fly and the distance to facade<br>
 +
[[File:Facade parameters.jpg|center|550px]]<br>
 +
11. Upload the route to the vehicle<br>
 +
12. Switch the vehicle to Auto mode<br>
 +
[[File:Upload-auto.jpg|center|350]]<br>
 
The drone should now take off and fly facade scan (snake type) route
 
The drone should now take off and fly facade scan (snake type) route

Revision as of 10:00, 11 February 2020

Main Page UgCS How to


1. Unfold and connect the software and hardware drone components
2. Launch UgCS for desktop
3. Click "Add new route"

Add new roue.jpg


4. Select "Create from scratch"

Scratch.jpg


5. Give a friendly name to the route
6. Select the used vehicle and click OK

Name.jpg


7. Input take off parameters if different from default and click OK

Takeoff.jpg


8. Select Facade scanning tool

Facade.jpg


9. Select the facade on the map to scan

Facade scan.jpg


10. Input the flight parameters such as turn type - "Stop and turn". Maximum and minimum height above the ground relief the vehicle should fly and the distance to facade

Facade parameters.jpg


11. Upload the route to the vehicle
12. Switch the vehicle to Auto mode

350


The drone should now take off and fly facade scan (snake type) route